JV100
T12 OLED Smart Electric Soldering Iron Kit PD 65W Repair Tool Adjustable Temperature Portable Solder Welding Station Heat Pencil
PD, QC voltage deception chips, and DC5521

2. Menu instructions:

Press the Middle button to enter menu, it will shows 9 options:

ACT: calibration ,HSL: brightness ,DMH: sleep ,LED: always on display ,LAG: language ,IMA:Screen display direction,OUT: power ,THB: Touch is to detect whether someone is operating,RTN: return

ACT: calibration （calibrate the temperature only suitable above 350 C, it cannot be calibrated below 350 C temporarily）

Insert the T12 tip to handle and power on,  set the temperature at 300, until the temperature in "real-time temperature" is stably display at 300, at this time, use a temperature measuring instrument to measure the temperature of T12 tip and record it. such as the measuring temperature is 350, then the calibration value is 50.

temperature is 250, then the calibration value is -50.

Calculation formula:  calibration value=measuring temperature - setting temperature

(Note: Before calibration, the value after calibration must be set to 0)

HSL: brightness

brightness adjustable range is 2-100 , 2 is darkest, 100 is the brightest

DMH: sleep

when screen is "DMH ON 5" ,It means that if the operator does not use the soldering iron for 5 seconds(automatically detect the use status of the soldering iron), the soldering iron will stop heating, and it will start heating again after picking it up.

when screen is "DMH OFF",It means that the soldering iron will always be in working condition, and the automatic detection function is turned off.

LED: always on display

when screen is "LED ON 5",It means that after 5 seconds of no key operation, the screen will be off, and when the key is operated again, the screen will light up again.

when screen is "LED OFF", It means the screen will stay on

LAG: language

Available languages are: Chinese , Engligh

IMA: Screen display direction

Can switch left-hand or right-hand operation display

OUT: power

This option indicates whether the power supply is stable. If the power supply is unstable, you can adjust the value appropriately. If screen flash, it is recommended to replace the power supply

THB: Built in capacitive touch IC detect whether someone is operating intelligent standby/sleep mode

Touch sensitivity refers to the recessed area on the handle to detect whether someone is operating. If no one is operating, it enters standby mode, and hibernates for a long time (provided that the Sleep inside is set to be turned on)

RTN: return

Return to main interface